creen 7:Relay output mode settings
S
This page is used to set the relay output mode.
The upper display shows "RO-M" word, this page
indicates relay output mode settings page, as shown
in fig. 3-3-10.
There are two kinds of modes of relay output:
Mode 1: relay output for the pulse output.
Mode 2: Relay output is self-maintained.
creen 8:Relay output pulse width settings
S
When the relay is set to pulse output mode, the page
is used to set the output pulse width. The upper display
shows "RO-T" word to make prompt, as shown in fig.
3-3-11.
A pulse width range of 50 to 20000 milliseconds.
Note: Only when the output mode is selected as
mode 1, t his screen is displayed, otherwise the page
is not displayed.
creen 9:Transmission output parameter settings
S
This screen is used to set the
parameters of transmission output . "AO"
on top of the page donates transmission
output 。
The first row is used to set the
direction
of AO,
bidirectional: 0 for unidirectional, 1 for
bidirectional.
The second row is used to set the associated type of
below.
The third row indicates the range of the corresponding electrical parameter, and the
IM300 Intelligent Power Monitoring Instrument
unidirectional
or
fig. 3-3-12 Transmission output settings page
37
Fig 3-3-10 Relay output mode settings page
Fig 3-3-11 Relay pulse width settings page
AO. As shown in the table