ABB IM300-I Operational Manual page 52

password set, the other bits are displayed as "-." After the input is complete press
button to confirm, if you enter the correct password is entered the local operation of
the first screen, otherwise stay on this page.
Screen 1: Output operation of relay 1
This page is used to control the on-off status of relay 1. The
top of the screen shown in fig. 3-4-2 displays the word "OUT",
expressed as output operation of relay 1 , the middle of the screen
displays "1" indicating that the relay 1.
Relay status after
the button or
that is "OPEN" indicates relay operation points, "CL" ie "CLOSE"
indicates relay closing operation.
Note: When the relay output is set to pulse output, you can
not select "OP", can only choose to "CL".
After selecting relay status, press
confirm whether or not the current operation prompts, as shown in
fig. 3-4-3. "Y" on behalf of YES, confirms that the local operation,
"N" on behalf of NO, that is, no local operation. Press
to make "Y" or "N" option, press
Select "N" press
operate. Select Y press
relay, but first check the current status of the relay: If the relay is
currently not operating, then the relay will be operated; current
relay under operation, the relay will not operate while the top of
the screen display "ERR" word indicates that the operation failed,
as shown in fig. 3-4-4. Now press
screen; press button to reset the relay status.
Screen 2：Output operation of relay 2
This page is used to control the on-off status of relay 2. The middle of the screen
IM300 Intelligent Power Monitoring Instrument
Press buttons "OP" blinking, press
bond can be "OP" or "CL" option. "OP"
button.
button to confirm, the relay does not
button is not immediately operate the
button will turn to the next
50
button appears to
button
Fig 3-4-2 The first relay
operation
Fig 3-4-3 Relay action
confirmation
Fig 3-4-4 Relay operation failed