Hydraulic Support Leg (Option For Cm 3300/4500); Jack Up The Sprayer - Hardi COMMANDER TWIN FORCE Instruction Book

4 - Sprayer setup

Hydraulic support leg (option for CM 3300/4500)

The hydraulic support leg is driven by a separate double acting hydraulic outlet on the tractor. The support leg is stored in
its retracted position when the sprayer is attached to the tractor.
To raise/lower the support legs
1. Pull the knob (A) to fold-up/down the support leg to/from its
storing position.
÷
NOTE! This does not apply to the CM 5500/7000 support leg.
2. Unlock the leg by turning the securing grip to position (A).
3. Use the tractor's hydraulic lever to raise or lower the support leg.
4. Secure the leg by turning the grip to position (B).
€
DANGER! Do never leave the sprayer standing unlocked on the
support leg. Always double check that the lever is in position (B).

Jack up the sprayer

When the sprayer needs wheel mounting, wheel changing, brake or
wheel bearing changing etc. then jack up the sprayer under the axle as
shown.
€
DANGER! Be sure to place sprayer at level and firm ground to
avoid sprayer falling down from the jack.
ATTENTION! It is good practice to use stop wedges at the
opposite wheel!
40