Manoeuvring Of The Boom - Haz - Hardi COMMANDER TWIN FORCE Instruction Book

Manoeuvring of the boom - HAZ

±
WARNING! The pendulum lock automatically turns ON when pressing one of the folding buttons. Boom folding is not
possible if the pendulum is unlocked. A manual override of the pendulum lock is possible by activating switches 2 or 3.
±
WARNING! Ensure that transport safety chains are removed and the boom is clear from the transport brackets before
unfolding.
±
WARNING! The folding functions must only be operated when the sprayer is stationary! Failure to do so will damage
the boom. The pendulum lock automatically opens at speeds exceeding 1.5 km/h!
ATTENTION! The boom can not be operated with the tractors hydraulic levers.
Only buttons relevant for boom functions are mentioned here. Refer to "SetBox controls" on page 29 for descriptions
of other buttons.
To unfold the boom
±
WARNING! The pendulum lock automatically opens when you begin to drive. Drive slowly until the pendulum is
completely unlocked.
1. Push the lift up button (H) to lift the boom clear of the transport
brackets. The symbol appears in display until pendulum is
locked. This takes approximately 10 seconds.
2. Push the button (5) to unfold the inner wings completely
(approximately 5 seconds or a warning will appear). Check that the
pendulum locked symbol
3. Push the buttons (7) to unfold the 1st outer wings.
4. Push the lift down button (I) to lower the boom to the correct
working height.
5. If not unlocked, then press (2) and
until pendulum is unlocked. This takes approximately 10 seconds.
To fold the boom
±
WARNING! If having SafeTrack is must be aligned and locked before folding.
1. Push slant buttons (E) or (F) to set neutral slant angle (no slant).
2. Push lift up button (H) to raise the boom to the highest possible
position.
3. Push the buttons (6) to fold the 1st outer wings. The
appears in display until pendulum is locked. This takes
approximately 10 seconds.
4. Push the button (4) to fold the inner wings. Check that the
pendulum lock symbol
5. Push the lift down button (I) to lower the boom until it rests in the
paralift locks.
6. Push tilt down buttons (B) and (D) to lower the individual tilt rams
until they rest on the front transport brackets.
is visible in the display.
symbol appears in display
is visible in the display.
symbol
A
B
E
5 - Operation
H
C
D
G
I
59