Sprayer Setup; General Info; Unloading The Sprayer From The Truck; Pulling The Sprayer At The Tie Down Hooks - Hardi COMMANDER TWIN FORCE Instruction Book

4 - Sprayer setup

General info

Unloading the sprayer from the truck

For the unloading of the sprayer, you need a crane. When unloading
with a crane please observe the lifting points as shown in the picture,
and make sure that the straps or belts used for lifting are strong enough.
ATTENTION! Only lift the sprayer when the tanks are empty!

Pulling the sprayer at the tie down hooks

For moving the sprayer or loading it to e.g. a truck it can be pulled in the hooks at the rear-end (A) and front-end (B) as shown.
COMMANDER 3300/4500
COMMANDER 5500/7000

Before putting the sprayer into operation

Although the sprayer has been supplied with a strong and protective surface treatment on steel parts, bolts etc. in the
factory, it is recommended to apply a film of anticorrosion oil (e.g. CASTROL RUSTILO or SHELL ENSIS FLUID) on all metal parts
in order to avoid chemicals and fertilizers discolouring the enamel.
If this is done before the sprayer is put into operation for the first time, it will always be easy to clean the sprayer and keep
the enamel clean for many years. This treatment should be carried out every time the protection film is washed off.
39