Breakaway Section Adjustment (32-36M); Hydraulic Slanting Control Adjustment; Hydraulic Slanting Control Adjustment (32-36M) - Hardi COMMANDER TWIN FORCE Instruction Book

Breakaway section adjustment (32-36m)

The breakaway section must release when a force of approximately 150
N is applied to the extremity of the breakaway section. If necessary, the
release force is adjusted as follows:
1. Make sure that claw coupling is correctly lubricated.
2. Loosen the counter nut (A).
3. Adjust the nut (B) until the breakaway will release at a force of 150
N applied at the extremity of the section.
4. Tighten the counter nut again.
€
DANGER! Never place fingers into open breakaway clutch! You
may be injured if clutch snap closed accidentally!
±
WARNING! Do not tighten the breakaway clutch more than what
is necessary. Over tightening can cause damage to the boom.

Hydraulic slanting control adjustment

Alignment of neutral position for the entire boom.
1. Place tractor and sprayer on even, flat ground.
2. Unfold the boom.
3. Slanting cylinder: Expose piston rod (A) 90 mm.
4. Adjust hinge ring (B) in/out till boom is horizontal.

Hydraulic slanting control adjustment (32-36m)

Alignment of neutral position for the entire boom.
1. Place tractor and sprayer on even, flat ground.
2. Unfold the boom.
3. Slanting cylinder: Expose piston rod (A) 90 mm.
4. Adjust hinge ring (B) in/out till boom is horizontal.
6 - Maintenance
99