Alpha ESS Storion-SMILE-T10 Installation Manual page 22

Your Smart Energy
Installation
Figure 18 Installation of the Bracket A of the Inverter
Step 10: Please remove the nuts from the rear bracket of HV50056 and fix the bracket
A of the inverter on the rear bracket of HV50056 with the flange nuts, as shown in
Figure 18.
The bottom of the bracket A shall be placed at the same horizontal line with
the rear bracket of HV50056.
Figure 19 Installation of the Bracket B of the Inverter
Step 11: Cover the PE bag on the top battery to block out the dust before drilling.
Please drill holes directly on the wall at the marking positions of the brackets with an
impact drill (bit φ 8.0mm, length 20cm), and the depth of each hole is about 7 cm.
Please insert the expansion tube into the drilled hole. Pass the tapping screw through
the gasket and lock with a screwdriver, as Figure 19 shows.
___________________________________________________________________
Alpha ESS Co., Ltd.
Page 20 of 46