Application Configuration Wizard; Tittle; Input Value For Parameters; Info - WEG CFW-11 Applications Manual

Project Tree on WLP

6.2 APPLICATION CONFIGURATION WIZARD

The Crane Horizontal Motion application can be configured with the WLP (WEG Ladder Programmer) software
using the configuration wizards, which consists of an oriented step by step guide for the configuration of the
parameters regarding the application.
NOTE!
When powering up the inverter for the first time follow the steps described in the chapter 5 "First
time Power-up and Start-up" of the CFW-11 user´s guide inverter. It is recommended to use the V/f
control mode for this type of application!
Figure 6.3 – Configuration wizard for Crane Horizontal Motion application

6.2.1 Tittle

The page title indicates that the feature is covered.

6.2.2 Input Value for Parameters

The input values for the parameters are spaces where are inserted values of drive parameters. Only after
finishing the configuration wizard, the same will be sent to CFW-11 frequency inverter.

6.2.3 Info

The info is to explain previously which of the selected parameter functionality, adjustable range and relevant
comments.

6.2.4 Browse Buttons

The configuration wizard has four kinds of browse buttons being:
■
Default: loads the default values of each parameter on the page in use;
■
Back: back to previous page;
■
Next: advance to the next page;
■
Cancel: close the configuration wizard without sending/save the values of the parameters edited.
Crane Horizontal Motion | 60