Status Word - WEG CFW-11 Applications Manual

Parameters Description
P1013 – Last Alarm Time
P1016 – Second Alarm Time
P1019 – Third Alarm Time
Adjustable 00.00 to 23.59
Range:
Proprieties:
RO
Access groups via HMI:
Description:
These parameters indicate the occurrence time (hour and minute) of the last to the third alarm in the HH.MM
format.

3.18.2 Status Word

This parameter group allows the user to visualize the status of the crane horizontal motion.
P1020 – Crane Horizontal Motion Status Word 1
Adjustable
0000h to FFFFh
Range:
Proprieties: RO
Access groups via HMI:
Description:
This parameter allows the status monitoring of the CFW-11 frequency inverter and of the crane horizontal
motion commands. Each bit represents a specific status.
Bits 15 to 10
Function
Bits
Bit 0 0: The inverter is general disabled.
General Enabled 1: The inverter is general enabled and ready to run the motor.
0: Stopped motor
Bit 1
1: The inverter is driving the motor at the set point speed, or executing either the acceleration or the
Running
deceleration ramp.
Bit 2 0: Motor in reverse speed direction
Rotation Direction 1: Motor in forward speed direction
Bit 3 0: Inverter in local mode
LOC / REM 1: Inverter in remote mode
0: The inverter is not in a fault condition.
Bit 4
1: The inverter has detected a fault.
Fault Condition
Note: The fault number can be read by means of the parameter P0049 – Present Fault.
Bit 5 0: No undervoltage
Undervoltage 1: Undervoltage
0: The inverter is not in alarm condition.
Bit 6
1: The inverter is in alarm condition.
Alarm Condition
Note: The alarm number can be read by means of the parameter P0048 – Present Alarm.
Bit 7
0: No load forward command
Load Forward
1: It indicates that a load forward command is being executed.
Command
01 PARAMETER GROUPS
∟ 50 SoftPLC
01 PARAMETER GROUPS
∟ 50 SoftPLC
Table 3.4 – Status word 1 description
9 8
.....
.....
7 6 5 4
Values
Factory Setting: -
Factory Setting:
-
3 2 1 0
Crane Horizontal Motion | 51