Spo Normal Operation (Accutorr Plus Model With Spo ); Spo2 Normal Operation (Accutorr Plus Model With Spo2) - Datascope Accutorr Plus Service Manual

SpO Normal Operation (Accutorr Plus model with SpO
2
5.10 SpO
SpO
The purpose of this test is to verify that an SpO
captured and the data is trended. A full operational test may be conducted, if so warranted,
within the limits of the published specification. See chapter 3 of this manual for
specifications.
1. Set the simulator to an SpO
2. Set the Accutorr Plus SpO
3. Connect an NIBP cuff or a suitable simulator to the Accutorr Plus and start a
4. Confirm that the Accutorr Plus has determined an SpO
5. Check the trend screen to confirm that the measurement information has been saved.
6. Set the SpO
7. Set the simulator to an SpO
8. The Accutorr Plus may intermittently determine SpO
9. Restore normal simulation parameters as described in step 1.
10. Remove the sensor from the simulator to induce a status code of 8851 (Sensor Off)
11. Disconnect the sensor from the Accutorr Plus to produce a status code of 8850 (No
5 - 20
)
2
Normal Operation (Accutorr Plus model with
2
)
2
pulse amplitude of 100%.
55 bpm.
measurement.
violated the SpO HI alarm and the pulse rate HI alarm (flashing digits and alarm
2
tone). Press the MUTE key to silence the alarms.
HI alarm to OFF and SpO
2
pulse amplitude to approximately 10% (low perfusion Masimo® SpO
of 8853 (Pulse Search) or 8854 (Weak Pulse / Low Perfusion will display). Adjust the
simulators pulse amplitude up and down until either status code of 8853 or 8854
displays.
(Masimo® SpO only).
2
Sensor).
0070-10-0691
signal is recognized, alarm limits are
2
saturation level of 98%, pulse rate of 60 bpm, and a
2
HI alarm limit to 95% and the pulse rate HI alarm limit to
2
LOW alarm to 86.
2
saturation level of 90%, pulse rate of 95 bpm, and the
2
saturation level and has
2
only).
2
values or indicate a status code
2
Accutorr Plus Service Manual
Calibration