Troubleshooting (Problem Isolation); Error Codes - Datascope Accutorr Plus Service Manual

Repair Information
3.5
3.5.0.1
Accutorr Plus Service Manual
To Purchase, Visit Avobus.com

Troubleshooting (Problem Isolation)

This section has been divided into two major areas: clinical and technical. Clinical
problems can generally be resolved by the user. Technical problems may require
resolution by a qualified technical service person. The error code table below indicates
Technical problems with an asterisk (*). Error codes are displayed on the front panel
LEDs of the Accutorr Plus.

Error Codes

TYPE CODE DESCRIPTION
NIBP 8810 Retry - Unable to Measure
8811 Retry - Pump Higher
8812 Stop - Cuff Overpressure
8813 Stop - Unable to Measure
TEMP 8830 Check Probe
(PTM)
8831 Replace Probe
SpO 8850 No Sensor
2
8851 Sensor Off
8852 Interference
8853 Pulse Search
8854 Weak Pulse
8856 Check Sensor
8857 PR<21
8857 PR<26
8858 PR>249
8858 PR>239
or call 1-800-674-3655
REASON
Motion artifact, cycle time-out,
weak pulsations or no pulsations.
A triple beep tone is generated.
Insufficient cuff pressure. A triple
beep tone is generated.
Excessive cuff pressure detected
by the software. A triple beep tone
is generated.
4 successive measurement
attempts failed. A triple beep tone
is generated.
Tissue contact may have been
lost.
Defective probe or connection.
No sensor connected.
Sensor not on patient.
(Masimo
Interference on signal.
(Masimo
Unit cannot find signal. (Nellcor
SpO
Search" -8853- when the sensor
is not on the patient.)
Weak pulse detected.
(Masimo
Sensor problem.
(Masimo
Pulse rate is less than 21 bpm.
(Nellcor
Pulse rate is less than 26 bpm.
(Masimo
Pulse rate is greater than 249
bpm. (Nellcor
Pulse rate is greater than 239
bpm. (Masimo
0070-10-0691

Troubleshooting (Problem Isolation)

®
SpO only)
2
®
SpO only)
2
®
module will report ''Pulse
2
®
SpO only)
2
®
SpO only)
2
®
SpO only)
2
®
SpO only)
2
®
SpO only)
2
®
SpO only)
2
3 - 5