Output, User Interface, And Control Connections - Extron electronics Annotator 300 User Manual

Output, User Interface, and Control Connections

HDMI connectors (2) — Connect suitable HDMI or DVI (with an adapter) displays to
E
these two connectors for HDMI or DVI output.
RJ-45 connector — Connect the Annotator 300 to a DTP receiver for selectable
F
DTP or HDBaseT output that supports the digital signal transmission of HDMI with
embedded audio and control up to 330 feet (100 meters) over shielded twisted
pair (STP) cable. Output format is selected by setting the HDBT/DTP switch
accordingly.
ATTENTION:
using DTP transmission. The power carried over DTP may damage the unit.
AVERTISSEMENT : Risque de dommages matériels. Ne PAS connecter une
unité HDBaseT si vous utilisez la transmission DTP. L'alimentation transmise sur
DTP peut endommager l'unité.
5-pole captive screw connector — Connect to this for bi-directional RS-232 over
G
DTP and IR insertion.
USB A connectors (2) — Connect up to twenty touchpanel devices (using USB
H
hubs), or a USB mouse and keyboard to these ports.
Reset button and LED — This button is used to reset the switcher to any one
I
of four different states. The LED indicates the status during the procedure (see
Resetting the Unit with the Reset Button
RJ-45 LAN connector — Connect the Annotator 300 to Ethernet LAN or WAN via
J
this RJ-45 connector. Ethernet control allows the operator to control the processor
from a remote location. When connected to an Ethernet LAN or WAN, the device can
be accessed and operated from a computer running a standard Internet browser. The
Link LED lights green when the Annotator 300 is connected to an Ethernet LAN, and
the Act LED flickers amber, indicating data transmission as the devices communicate.
RS-232 3-pole captive screw connector — This connector provides for two-way
K
RS-232 communication. Connect a host computer or control system to this for serial
RS-232 control. The default protocol is 9600 baud, 1 stop bit, no parity, and no flow
control.
Remote contact closure 3-pole captive screw connector — Connect a host
L
device to this 3-pole connector for remote contact closure control.
Risk of property damage. DO NOT connect an HDBaseT unit if
Annotator 300 • Rear Panel Features and Connections
on page 14 for details).
11