Lan/Ethernet Connection; Default Settings; Pin Allocation; Figure 46, Pin Allocation Of The Lan Network Cable (Rj45) For Panel Mounting Only - Baer DLX User Manual

9.3

LAN/Ethernet connection

9.3.1

Default settings

After delivery the following settings are active for the Ethernet interface:
•
S0=1
•
&D0
•
T
•
#PORT=1234
•
#DTC=60
•
#GW=0.0.0.0
•
#NM=255.255.255.0
•
#IP=0.0.0.0
•
Q1
•
&W
The modem will respond after the first detected ring (S0=1). These settings
are fixed by factory programming. Only the IP-address must be altered in
field: via DLXPARA, menu: Communications: Modem init. String (Com2):
AT#IP=a.b.c.d (click on "Set"-button, turn off DLX and after some seconds
o again).
For more detailed information (e.g. set gateway: AT#GW=a.b.c.d ) please
consult the manual shipped with the software DLXPARA.
9.3.2

Pin allocation

The connection between the Ethernet-interface (terminal X5) and a LAN-
line for panel mounting uses a network cable (converter) of type RJ45 to
RJ12/RJ25; for 19"-rack uses a standard RJ45 cable (standard LAN).

Figure 46, Pin allocation of the LAN network cable (RJ45) for panel mounting only

Respond after one ring
Ignore DTR
TCP/IP-Mode
Port 1234
Data Transmit Control (60 seconds)
Gateway 000.000.000.000
Net-Mask
IP-Address
No feedback messages
Save user settings in non-volatile memory
RJ45 Code
1 TX+
2 TX-
3 RX+
6 RX-
RJ12
4
5
3
2
87