Outputs - Baer DLX User Manual

3.10

Outputs

The DLX data logger (remote metering device) can have up to 6 freely pro-
grammable outputs, which are available in wipe technology (Out1 to Out4,
type IAW) and as mechanical relays (Rel1 and Rel2). Corresponding light
emitting diodes (LED) in the display show the state of each output (output
closed or active: LED is lit). The following functions are possible:
•
Total 1 to 4:
•
MPA1 and 2:
•
RSTA:
•
Alarm1 and 2: output for warning messages (Alarm1) and device faults
•
TRA1 to 4:
Energy rate
where: state "1": output is active (closed), output LED is lit
•
Log1 to 4:
•
In1 to 16:
These functions can allocated to more than one output at the same time
(pulse multiplication exists for version 1.04.00 and up).
38
pulse output for total registers (only with Out1 to Out4)
output indicating the end of registration period Tm1 or Tm2
reset output
(Alarm2)
Rate control outputs. After a unit restart the following fac-
tory settings are active:
TRA1 TRA2
AT1 0
AT2 1
AT3 0
AT4 1
state "0": output is non active (open), output LED is off
logic outputs, used to forward signals to externally con-
nected devices. Control of the logic outputs is performed
via remote data retrieval.
pulse inputs can be redirected (1 to 1) to outputs (for ver-
sion 1.04.00 and up). No conditioning of pulse lengths or
signal type is performed.
Demand rate
0 MT1
0 MT2
1 MT3
1 MT4
TRA3 TRA4
0 0
1 0
0 1
1 1