Main Menu Item "Info - Baer DLX User Manual

7.7

Main menu item "Info"

How to get there
Press the key twice when in the standard display and then press the
key.
What does the display show ?
The display will show the current values (cumulative and current energy,
demand and pulses), the load profile values from the registration period
(Tm1 or Tm2: energy values, increments or demand values) as well as bill-
ing data, spontaneous events, table addresses and information about the
current firmware version. It is possible to show all values stored in internal
memory (load profiles and billing data) in the display. All values are dis-
played with 4, 6 or 8 digits and their correct physical units (depending on
the parameters set with DLXPARA). Starting from Version 1.04.00 one or
two decimal places are possible, starting from Version 1.05.00 up to three
decimal places are possible
Item selection
Use the keys on the front panel to select the required value from the inter-
nal memory via its parameters:
moves to the next parameter, after the last parameter moves to the first pa-
rameters (this corresponds to a key).
returns to the original menu.
increases the selected parameter to the next higher possible value.
decreases the selected parameter to the next lower possible value.
One digit of the selected parameter blinks in the display. On each change
of the parameters the measurement display will be updated.
If no value is available for the selected parameters, then automatically the
next valid entry from the registration period buffer will be displayed. This is
an easy method to request the oldest or newest load profile entry: modify
the input field for the year with the or the key until there are no further
changes of the display: the display now shows the oldest load profile entry
(after using the key) or the newest load profile entry (after using the
key). Invalid values or values incompatible with memory entries cannot be
requested.
When displaying energy or demand values from the load profile memory,
the unit always shows the total value (not rate related) together with the ac-
tive energy and demand rate valid at the end of the registration period (you
cannot edit the rate).
When displaying billing data, the values are shown depending on the rate,
which can be selected. Each entry can only be selected by the secondary
reset index (0..99), the primary reset index (1..12, settable) will be dis-
played automatically.
The unit differentiates between inputs (I01 to I16), totals (S01+ to S04-),
apparent demand / cos( ϕ ) (X01/X02 or P01+ to P02-): only the values pro-
grammed for the corresponding registration period will be displayed.
The physical unit displayed must be programmed with DLXPARA.
61