Baer DLX User Manual page 144

1.5 SCTM telegrams (subset)
The DLX supports the following SCTM telegrams:
BUFENQ1 (E4)
NEXTi (E5)
BUFENQ2 (E6)
NEXTBLOCK (HEADER) Retrieval of the following data block.
TABENQ1 (E1)
TABENQ3 (E3)
SETTIME (T1)
SETTIME_T9 (T9)
SSYNC (T2)
MSYNC (T4)
TABSET1 (S1)
IACPASS2 (P)
A 34
Retrieval of individual buffer entries.
Retrieval of the following buffer entry.
Retrieval of a continuous block of data from a
load profile buffer.
Retrieval of listed table addresses.
Retrieval of date and time (resolution in seconds)
Retrieval of buffer information (no. of values, no.
of decades, measuring period) (possible for ver-
sion 1.04.01 and up)
Sets the time to be programmed into the DLX.
This command only works if it was previously
enabled by using DLXPARA
Sets the time with seconds to be programmed
into the DLX (possible for version 1.04.01 and
up)
This command only works if it was previously
enabled by using DLXPARA
Change the time in the DLX to the previously set
time.
Year, month, day, hour and minute will be
changed to the values set with the SETTIME
command, seconds will be set to 0. This com-
mand only works if it was previously enabled us-
ing DLXPARA.
Synchronize
The seconds will be set to 0. If the second value
was between 30 and 59, the minute value will be
increased. This command only works if it was
previously enabled using DLXPARA.
Remote program change (set table addresses).
Currently only the logic outputs can be set (ad-
dress 661-nn).
Password (possible for version 1.04.00 and up)