Program Protection Switch; Figure 4, Program Protection Switch By Housing For Panel Mounting; Figure 5, Program Protection Switch By 19"-Rack - Baer DLX User Manual

For programming of the DLX a PC needs to be connected to the V.24 ser-
vice interface of the DLX. Programming of the DLX is only possible with the
programming software DLXPARA. For details of the programming software
please read the user manual shipped with the software.
Before setting (or changing) any parameters of the DLX a reset (to fac-
tory settings) should be executed. Modification of some parameters
(see menu item „Internal memory", page 33) will cause the unit to
automatically erase the registration period buffers.
During the setting of parameters of a DLX the data retrieval is dis-
abled due to reasons of data security.
3.4.1

Program protection switch

Figure 4, Program protection switch by housing for panel mounting

Figure 5, Program protection switch by 19"-rack

Before transferring any parameters to the DLX unit, the program protection
switch must be set to "Enable". The program protection switch is located on
the underside of the display board of the DLX.
17