Main Menu Item "Set Parameters; Factory Settings (Unit Restart Or System Restart); Figure 39, Flow Diagram For Menu "Set Parameters - Baer DLX User Manual

7.8

Main menu item "Set Parameters"

Figure 39, Flow diagram for menu "Set Parameters"

How to get there
Press the
You can now select between submenu items:
•
Factory settings
•
Erase memory
7.8.1

Factory settings (Unit restart or system restart)

How to get there
Press the
"Factory settings" is protected by a password and can only be selected
when programming is enabled (program protection switch is in position "Set
Enable", see page 17).
Password protection
The function "Factory settings" (System Restart) can be activated with the
password for FACTORY SETTINGS . After entering the correct password
(see „Password input" on page 56) the function will be executed.
What is going to happen?
The function "Factory settings" will set all parameters to the factory settings
(see page 95), clear the internal memory and erase the internal clock.
Execution of a system restart
After entering the password the display will show the safety question "Reset
all parameters to factory values ?". Press the
DLX unit will now check the state of the program protection switch (see
page 17). Only if the switch is in position "Set Enable" will a system restart
be executed. If you press the
If the program protection switch is in position "Set Disable" (programming
blocked, secured certification mode), the message "programming disabled"
will be displayed. The DLX will exit the menu item without executing a sys-
tem restart.
70
key three times when in standard display and then press the
key.
-key when in menu item "Set Parameters". The function
key to confirm. The
key, no system restart will be executed.