Audi AMB Service Manual page 93

ENGINE 1.8 Liter 4-Cyl. 5V Turbo Engine Mechanical, Engine Code(s): AMB
Bearing cap 1: pulley end

Bearing shell retaining lugs of cylinder block/bearing cap must be on same side

4 - Bearing shell 3 (top)
For bearing cap without oil groove

For cylinder block with oil groove

Do not interchange used bearing shells (mark)

5 - Thrust washers
For bearing cap, bearing 3

Note fixing arrangement

6 - Sensor wheel
For Engine speed (RPM) sensor G28

Can only be installed in one position, holes are offset

Always replace sensor wheel if bolts have been removed

Removing and installing Removing and installing sensor wheel

7 - 10 Nm + 1/4 turn (90 ° ) further
Replace

Always replace sensor wheel if bolts have been removed Removing and installing sensor wheel

8 - Pilot needle bearing
Pulling out and driving in --> Pilot needle bearing in crankshaft, extracting and driving

9 - Crankshaft
Axial clearance, New: 0.07...0.23 mm; Wear limit: 0.30 mm

Check radial clearance with Plastigage™
New: 0.02...0.04 mm

Wear limit: 0.15 mm

Do not rotate crankshaft when checking radial clearance

Crankshaft dimensions --> Crankshaft dimensions

10 - Bearing shell 3 (bottom)
2005 Audi A4 Quattro
1:00:59 AM Page 81