Audi AMB Service Manual page 426

ENGINE 1.8 Liter 4-Cyl. 5V Turbo Engine Mechanical, Engine Code(s): AMB
For bearing cap without oil groove

For cylinder block with oil groove

Do not interchange used bearing shells (mark)

11 - Chain sprocket
Drive for oil pump

Replacing --> Chain sprocket, removing and installing

Removing and installing sensor wheel
Fig. 126: Identifying Attachment Points, Countersunk Screws, Crankshaft & Sensor Wheel
Courtesy of VOLKSWAGEN UNITED STATES, INC.
NOTE:
Always replace sensor wheel - 2 - if bolts - 1 - have been removed.

If the securing bolts are tightened a second time, seats for the

countersunk bolt heads in the sensor wheel will be distorted to such an
extent that the bolt heads will come into direct contact with the crankshaft
- 3 - - arrows - and the sensor wheel will only fit loosely under the bolts.
It is only possible to install the sensor wheel in one position, mounting

holes are offset.
Tightening torque
Component
Sensor wheel to crankshaft
*Replace bolts
* 90 ° is one quarter turn
Identification of top crankshaft bearing
2005 Audi A4 Quattro
2:33:17 AM
10 + 90 ° * See note
Page 49
Nm