Audi AMB Service Manual page 316

MANUFACTURER'S SUGGESTED SCHEDULED MAINTENANCE
The manufacturer suggests the belt be replaced at 105,000 mile intervals under normal driving conditions,
52,500 mile intervals under severe driving conditions.
REMOVAL & INSTALLATION
CAUTION: This application is an interference engine. Do not rotate camshaft or
crankshaft when timing belt is removed, or engine damage may occur.
TIMING BELT
NOTE: Many service operations are made easier by moving lock carrier into service
position.
Removal (Avant & Sedan)
1. Raise and support vehicle. Remove front tires. Remove bolts and quick release screws (1 and 2). See Fig.
1 . Rear noise insulation (3) remains installed.
2. For vehicles with auxiliary heater, remove bolts for exhaust pipe of parking/auxiliary heater at noise
insulation. See Fig. 2 .
3. Remove right cover in engine compartment. Unbolt air guide between lock carrier and air filter on lock
carrier. Remove left cover in engine compartment. Pull off hood seal from lock carrier and fender edges.
4. Loosen left and right wheelhousing liners in front area. See Fig. 3 . Pull back wheelhousing liner (A).
Remove bolt (2) and nuts (1). Unclip bumper rear edge from catch (B). See Fig. 4 . Repeat procedure on
opposite side of the vehicle.
5. Release catches (1-4) using a screwdriver and remove air inlet grille on left and right on bottom part of
bumper. See Fig. 5 . Remove left and right retaining bolts until bumper is fully released. See Fig. 6 .
6. If installed, disconnect hose (1) to headlight cleaning system. Disconnect harness connectors (2) and
remove bumper. See Fig. 7 .
7. Inspect headlight and turn signal electrical connectors and wiring harness (which may hang up when lock
carrier is moved forward).
8. On right side, remove bolt (5) and install support tool (3369) in its place. See Fig. 8 and Fig. 9 .
9. On left side, install support tool (3369) in threaded hole in chassis. See Fig. 10 .
10. Remove on both sides, all bolts (2). See Fig. 8 .
11. Remove on both sides, all bolts (3 and 4). See Fig. 8 . Slide lock carrier forward unit the rear bolt hole in
lock carrier aligns with the forward threaded fender bolt hole.
12. Secure lock carrier in this position, by placing fender bolts in holes. See Fig. 11 . To install, reverse
placing in service position procedure.
2005 Audi A4 Quattro 2005 Audi A4 Quattro
AUDI 1.8L 4-Cylinder Turbo - AMB Engine - 2002-04 A4 AUDI 1.8L 4-Cylinder Turbo - AMB Engine - 2002-04 A4
1.8L 4-Cylinder Turbo - AMB Engine - 2002-04 A4
12:44:10 AM 12:44:06 AM
AUDI
Page 1 Page 1