Audi AMB Service Manual page 342

Fig. 23: Identifying Torque Support Bolts (Avant & Sedan)
Courtesy of AUDI OF AMERICA, INC.
Installation (Cabriolet)
1. Place timing belt on crankshaft sprocket (if reusing belt, observe direction of rotation). Install lower part
of timing belt cover. Install vibration dampener. The hole in the vibration damper must be located over
the raised part on the crankshaft timing belt sprocket. Tighten vibration damper/pulley to specification.
See TORQUE SPECIFICATIONS .
2. If necessary, align camshaft sprocket-to-cylinder head cover positioning marks and vibration damper-to-
timing belt cover positioning marks. See Fig. 14 . Install timing belt in this order: water pump, tensioning
pulley, camshaft sprocket.
NOTE: If the timing belt tensioner has not been restrained and is at its travel limit,
it must be pushed back in the installed position together with the pulley.
This procedure can take up to 5 minutes. When compressing the
tensioner, excessive force can damage the tensioning pulley. Push pulley
on counterclockwise in direction of arrow with a socket head wrench
using even (but not excessive) application of force until tensioner piston
can be locked with Locking Plate (T10008). See Fig. 15 .
3. Turn eccentric bolt counterclockwise in direction of arrow using special tool (3387). See Fig. 21 . Hold
2005 Audi A4 Quattro
AUDI 1.8L 4-Cylinder Turbo - AMB Engine - 2002-04 A4
12:44:07 AM Page 27