Audi AMB Service Manual page 172

ENGINE 1.8 Liter 4-Cyl. 5V Turbo Engine Mechanical, Engine Code(s): AMB
Apply silicone sealant: D 176 404 A2 before installing

Removing and installing --> Oil pan, removing and installing

4 - Oil pump
With pressure relief valve, 12 bar

Removing and installing --> Oil pump, removing and installing

Replace pump if there is scoring on moving surfaces and gear teeth

Tightening torque for oil pump cover to oil pump housing: 10 Nm

5 - Oil pump chain sprocket
Sprocket can only be installed on oil pump shaft in one position

6 - 22 Nm
7 - Drive chain for oil pump
Mark direction of rotation before removing

Check for wear

8 - 15 Nm
9 - Front sealing flange
Apply silicone sealant D 176 404 A2 before installing --> Sealing flanges and flywheel/drive plate,

removing and installing
Replacing crankshaft oil seal -pulley end --> Crankshaft oil seal - pulley end, replacing

10 - Chain tensioner
Tighten to 16 Nm

Do not disassemble

Note installed position

Pre-tension spring and engage before installing

If spring is broken, replace complete chain tensioner

11 - Oil pump chain sprocket
Removing and installing --> Chain sprocket, removing and installing

12 - Dowel sleeves
2005 Audi A4 Quattro
1:01:08 AM Page 160