Audi AMB Service Manual page 463

ENGINE 1.8 Liter 4-Cyl. 5V Turbo Engine Mechanical, Engine Code(s): AMB
12 - Bearing cap for intake camshaft
Must be located on dowel sleeves

Dowel sleeves must be located in cylinder head

Note installed position

Installation sequence

13 - Double bearing cap
Must be located on dowel sleeves

Dowel sleeves must be located in cylinder head

Apply small amount of AMV 188 001 02 to sealing surface before installation

Sealing transition points between double bearing cap and cylinder head Sealing transition points

between double bearing cap and cylinder head (2 points):
14 - Exhaust camshaft
Check radial clearance with Plastigage™ (valve lifters not installed): Wear limit: 0.1 mm; Run-out: max.

0.035 mm
Checking axial clearance --> Camshaft axial clearance, checking

Removing and installing camshafts --> Camshafts and camshaft adjuster, removing and installing

15 - Bearing cap for exhaust camshaft
Must be located on dowel sleeves

Dowel sleeves must be located in cylinder head

Note installed position

Installation sequence

16 - 10 Nm
17 - 10 Nm
18 - Drive chain
Check for wear

Mark position of chain before removing Clean chain and camshaft sprockets opposite two under

Removing
Removing and installing --> Camshafts and camshaft adjuster, removing and installing , Camshaft,

removing and installing
19 - Camshaft adjuster
2005 Audi A4 Quattro
2:34:42 AM Page 26