Table of Contents
Advertisement
Start-up
To start up the VVT Zone Controller, you need one of the following user interfaces. These items let you access
the controller information, read sensor values, and test the controller.
This interface...
i-Vu Open
software
Field Assistant software -
runs on a laptop connected to controller's Local Access port
Virtual BACview software -
runs on a laptop connected to controller's Local Access port
BACview6 Handheld keypad/display unit -
connects to controller's Local Access port
BACview6 keypad/display unit
connected to controller's Rnet port
1
Requires a USB Link (USB-L).
2
See the BACview Installation and User Guide for instructions on connecting and using the above items.
Configuring the VVT Zone Controller's properties
To start up the VVT Zone Controller, you need to configure the properties described in the following sections.
These properties affect the unit operation and/or control. Review and understand the meaning and purpose
of each property before changing it.
•
Unit Configuration properties
•
Setpoint Configuration properties
•
Service Configuration properties
•
Linkage properties
See Appendix A (page 51) for a complete list of the controller's points/properties.
NOTE Engineering units shown in this document in the defaults and ranges are strictly for reference. You
must enter an integer only.
VVT Zone Controller
1, 2
2
(page
30
)
(page
30
)
(page
33
)
(page
34
)
Provides a...
Permanent interface
Temporary interface
1
Temporary interface
1, 2
Temporary interface
Permanent interface
29
Hide quick links:
Advertisement
Table of Contents
