Brake Cable; Enrichener Ca Ble - Suzuki Intruder 1978 Service Manual

Brake Cable
Removal
1. Remove the return spring and disconnect the
brake cable tip from the retainer. (See Figure
3-97.)
1. Locknuts
2 . Return Spring
3. Retainer
4 . Brake Cable Bracket
Figure 3-97
2. Remove the locknuts f rom the brake cable .
3. Remove the snap ring and disconnect the
brake cable end from the brake lever. (See
Figure 3-98.)
1 _~
~
2
1. Snap Ring
2. Brake Cable End
3. Brake Cabl e Tip
Figure 3-98
3-70
ENRICHENER CABLE
Installation
1. Place the end of the brake cable through the
brake lever assembly and install the snap r ing.
2. Connect the brake cab le end to the brake lever.
3. Instal l one locknut on the end of the brake
cable and place it th rough the brake cab le
bracket. (See Figure 3-98.)
4 . Install the second locknut on the end of the
brake cable. Install the brake cab le tip to the
retainer and connect the return spring. For
brake cable adjustment see Section 2.
Enrichener Ca ble
Removal
1. Unscrew the enrichener switch nut. (See
Figu re 3-99.) Sepa rate the enric hener swi tc h
from the panel.
1. Enrichener Switch Nut
2. Enr ichener Switch
Figu re 3 -99
2. Lift the plastic cap up fro m the enrichene r
cable and unscrew the starter plunger cap.
(See Figure 3-100.) Remove the enrichener
plunger assembly from the carburetor.
3. Unscrew the fitting, compress the enrichener
plunger spring and disconnect t he enrichener
cable from the plunger .
Installation
1. Slide the enrichener switch through the ho le in
the panel and install the enrichener switch
nut. (See Figure 3-99 .)
2. Slide the enrichener plunger cap, washer and
spring over the end of the enrichener cable .
(See Figure 3- 100.)