Suzuki Intruder 1978 Service Manual page 107

Muffler
Removal
1. Remove the springs that secure the muffler to
the exhaust manifold . (See Figure 3-13.)
1. Spring
2 . Nut and Washer
3. Muffler
4. Exhaust Manifold
Figure 3 - 13
..-/" 1
®
5 ~ G- 2
o
6 - ~
rlb
4- y
I
Ie
1
G _ _ _
~
----2
~- 3
Y - - 4
(')
1- - 5
I
® _ _
6
~
2
- - - 1
2 --~
1 /
8 ~
1
7
1. Nut
2. Washer
3 . Rear Muffler Bracket
4. Damper
5. Insulating Washer
6. Insulating Shoulder Washer
7. Spring
8 . Muffler
Figure 3 - 14
3 -34
AIR INTAKE SILENCER
2. Remove the nuts and washers that secure the
muffler to the mounting brackets .
3. Remove the muffler from the snowmobi le by
separating it from the exhaust manifold flange,
and guiding outlet pipe out of exhaust outlet
boot .
Installation
Install the muffler by reversing the removal pro-
cedure . Make sure the insulation washers are
properly positioned on each side of the muffler
brackets . (See Figure 3-14.)
Air Intal<e Silencer
Removal
1. Remove th e drive bel t guard .
. 2. Disconnect the springs from the intake si len -
cer. Note position of long and short springs.
Remove the air intake silencer from the snow -
mobile. Check the seal in between the upper
and lower halves of the intake si lencer. If there
is any sign of a possible air leak reseal the two
halves with silicone sealer. Install a new cable
tie band around the si lencer assembly to se-
curely fasten the cover to the si lencer body.
(See Figure 3 - 15).
1. Long Spring
2. Short Spring
3. Carburetor
4 . Air Intake Silencer
Figure 3-15