Suzuki Intruder 1978 Service Manual page 169

5. Remove the bolt and nut holding the primary
tie rod to the steering column .
6. Remove the bolts and nuts from the upper
mounting blocks and lower mounting brackets .
7. Remove upper split bushing and lower damper;
withdraw steering column upward through the
key switch panel.
8 . Remove bolt and washer securing lower
handle bar holder to top of steer ing pole and
lift off lower holder .
NOTE: During reassemb ly, front of key switch
panel bracket must be mounted behind the bracket
on the upper steering mount assembly to prevent
the steering pole from turning over center during a
full-lock t urn. (See Figure 3-150.)
6
ll}
28 20
~
16
I
1
21,
27 /
K
J
G
I I
26 23,
25
22
Lbr- : h
I
32 I
~
23,
~25
/
24
~
/
~-21,27
'--22
3-96 STEERING AND SKIS
1 - \\
Figure 3-151
1. Panel Bracket
2. Bracket on Upper Steering Mount
Figure 3-150
1. Steering handle
2. Wire Clamp
3. Handle Holder
4. Screw
5. Handle Grip
6. Bolt
7. Special Washer
8. Handle Holder
9. Special Washer
10. Bolt
11. Upper Mount Block
12. Bushing
13. Insert Nut
14. Steeri ng Pole Asse mbly
1 5. Base Bracket
1 6. Insert Nut
17. Tie Rod
18. Bolt
1 9. Left Steeri ng Arm
20. Wave Washer
21. Tie Rod End
22. Bolt
23. Nut
24. Tie Rod
25. Nut Special
26. Bolt
27. Tie Rod End
28. Right Steering Arm
29. Tie Rod End
30. Adjusting Stud
31 . Bolt
32 . Tab Locking Washer
33. Upper Bracket
34. Damper