Light Regulator Replacement - Suzuki Intruder 1978 Service Manual

Installation
Install tail lamp assembly in the reverse order of
removal. During reinstallat ion of the seat carefully
torq ue the four mou nti ng bolts as the nuts inside
the seat ca n be easily stripped .
1. Harness
2. Nut
3. Tail Lamp Body Assembly
4 . Bulb
Figure 3-94
Light Regulator
Replacement
5. Gasket
6 . Screw
7 . Lens
1.
Disconnect the light regulator connector from
the main harness.
2.
Remove machine screw, lockwasher and lock-
nut, and remove the light regulator.
3 . Install light regulator in the reverse order of re -
moval. Tighten machine screw to 95 in . Ib
(1 .09 kg-m).
Throttle Cable and
Oil Pump Cable
Removal
1. To re move the throttle cable from each car-
buretor, unscrew the mixing body top assem-
bly and pullout the throttle slide valve
assembly. (See Figure 3-95.)
2 . Compress the throttle spring and remove the
thrott le spring seat plate .
3. Slide the throttle cable tip to the larger hole in
the base of the throttle slide valve and separ-
ate the throttle cable from the throttle slide
valve .
1. Mixing Body Top Assembly
2.
Throttle Slide Valve Assembly
3. Spring
4. Throttle Spri ng Seat Plate
Figure 3-95
4. Loosen the throttle cab le locknut and unscrew
the throttle cable from the mixing body top
assembly. (See Figure 3 -95 .) Loosen clamp
screw and remove LH carburetor from car-
b uretor holder.
5. Loosen the locknut of the oil pump cable which
is toward the engine .
6 . Remove the cable from the inlet plate bracket .
Move the oil pump control lever to the full on
position and disconnect the cable from it.
7. Remove snap ring and disconnect the throttle
cable end from the throttle lever. (See Figure
3-96 .)
Installation
1. Slide the throttle cable through the throttle
lever assembly and install the snap ring . (See
Figure 3-96.).
2. Connect the throttle cable end to the throttle
lever.
3. Reconnect the oil pump cable to the oil pump.
Install the LH carburetor and secure to holder
assembly by tightening the clamp screw.
4 . Screw the throttle cab le into the mixing body
top assembly. (See Figure 3-95.)
3-68 THROITLE CABLE AND OIL PUMP CABLE