Optional Equipment Setup - Wells M42004 Owner's Manual

OPTIONAL EQUIPMENT SETUP

ALLOW THE UNIT TO COOL COMPLETELY BEFORE PERFORMING ANY SERVICE OR MAINTENANCE.
MAKE CERTAIN THE OVEN IS PROPERLY SUPPORTED DURING ANY INSTALLATION WHICH REQUIRES
THE OVEN TO BE RAISED OFF ITS BASE OR TO SIT ON ITS SIDE SO THE BASE MAY BE EASILY ACCESSED.
SERVICE/INSTALLATION PROCEDURES SHOULD BE PERFORMED BY AUTHORIZED TECHNICIANS ONLY.
THE OVEN SHOULD BE DISCONNECTED FROM POWER BEFORE ANY SERVICE PROCEDURE.
CASTER KIT [WS-21330]
i. Reposition the oven so that the bottom can be easily and safely accessed.
ii. Install the casters into the oven. The locking casters have to go in the front two [2] positions.
The non-locking casters go in the back two [2] positions.
iii. Set the unit upright, on the casters, and move the unit to its desired destination.
iv. Check that the unit is level form side to side as well as front to back and make adjustments to the
casters as necessary.
LEG KIT [WS-22829]
i. Reposition the oven so that the bottom can be easily and safely accessed.
ii. Adjust the legs to be approximately the same height and install the legs into the oven.
iii. Set the unit upright, on the legs, and move the unit to its desired destination.
iv. Check that the unit is level form side to side as well as front to back and make adjustments to the
legs as necessary.
VENT KIT [WS-505504]
i. Remove the two [2] screws holding the top of the vent plate on the rear,
left of the oven.
ii. Loosen, but do not remove, the lower two [2] screws and remove the
vent plate.
iii. Slide the lower flange of the vent kit adapter over the two [2] loosened
screws.
iv. Place the two [2] top screws back in place and tighten all four [4] screws.
v. Attach the vent adapter to an appropriate ventilation system based on
all codes and regulations pertaining to the installation location.
PREP TOP KIT [WS-21445]
i. Attach the four [4] mounting brackets to the prep
top with the four [4] supplied mounting screws.
Snug the screws, but do not fully tighten.
ii. Remove the four [4] screws that attach the oven
top panel.
iii. Carefully place the prep top over the top of the
oven and place the four [4] screws that were
removed from the oven top panel through the
bracket holes, then thread them into their original
positions.
iv. Making certain the prep top is level, tighten all
eight [8] screws.
PREP TOP
OVEN TOP PANEL
27