Table of Contents
Advertisement
3-17.
SPECIAL
PROGRAM
MODE
(CONT.)
Oct. 2005
e.
Change the idle setpoint temperature, by pressing ▼▲.
f.
Press and release (PROG►) . "SP-7B" and "AUTO-IDLE
MINUTES" show in the display, along with the preset time.
g.
Press ▼▲ to set the minutes the fryer stays idle before the
Auto-idle is enabled; 60 the maximum, OFF the minimum.
Ex., "30" in the display means, if product is not cooked in
that frypot for 30 minutes, the control automatically activates
the idle setpoint temperature, programmed above.
h.
Press and release (PROG►). "SP-7C" and "GO IDLE AT
MELT EXIT?" show in display.
i.
Press ▼▲to toggle from NO to YES, or vice versa. With
"YES" in the display, the fryer automatically enters the Idle
Mode once the Melt Mode is exited.
FILTER TRACKING ENABLED (SP-8)
The controls can be set to signal the operator when the shortening
needs filtering. The Filter Tracking must be enabled to program
the number of Cook Cycles between filtering procedures. (See
Filter Cycles paragraph 3-16.)
a.
Follow steps 1 and 2 above.
b.
Press and release (PROG►) until "SP-8"and "FILTER
TRACKING ENABLED" flash on the display, along with
"1,OFF".
c.
To enable the filter tracking, press ▼▲ to toggle the display
from "1,OFF", to "2,MIXED", or, "3,GLOBAL"
The Mixed setting allows the operator to set different
amounts of Cook Cycles, between filters, for each
product. If the operator wants to have one setting for
all products go to step h.
d.
If "2,MIXED" is selected, press (PROG►) and "SP-8A"
shows in the display followed by "SUGGEST FILTER AT
..." and a value between 75% and 100%. Press and release
▼▲ to change this value.
e.
Press (PROG►) and "SP-8B" shows in the display followed
by "LOCKOUT ENABLED?" and "YES" or "NO". Press
and release ▼▲ to choose YES or NO.
f.
Press (PROG►) and "SP-8C" shows in the display. "FILTER
LOCKOUT AT..." and a value between 100% and 200%
show in display. Press ▼▲ to change this value.
48
Advertisement
Table of Contents
