Henny Penny OFE-391 Operator's Manual page 53

3-17.
SPECIAL
PROGRAM
MODE
(CONT.)
July 2003
LANGUAGE (SP-2)
a. Follow steps 1 and 2 above.
b.
Press and release (PROG►) button. "SP-2" and
"LANGUAGE" flash on the display, along with the language
(Ex., "1.ENGL").
c.
To toggle to the desired language, press and release ▼▲.
SYSTEM INITIALIZATION (SP-3)
This step resets the controls, but doesn't erase product settings.
a. Follow steps 1 and 2 above.
b. Press and release (PROG►) twice. "SP-3" and "DO
SYSTEM INIT" flash on the display, along with "INIT".
c.
Press and hold ▼. "INIT" shows on the display, a tone
sounds, and "IN 3", "IN 2", " IN 1" flash on the right side
of the display. When "INIT" starts flashing on the left side
of the display, release ▼ . When " DONE" shows on the
display, the initialization is complete, and the controls now
have factory preset parameters.
AUDIO VOLUME (SP-4)
The volume of the speaker can be adjusted.
a.
Follow steps 1 and 2 above.
b.
Press (PROG►) 3 times. "SP-4" and "AUDIO VOLUME"
flash on the display, along with the volume value.
c.
Press ▼▲ to adjust the speaker volume; 10 the maximum
value and 1 the minimum.
AUDIO TONE (SP-5)
The tone of the speaker can be adjusted.
a.
Follow steps 1 and 2 above.
b.
Press (PROG►) 4 times. "SP-5" and "AUDIO TONE
(HZ)" flash on the display, along with the tone value.
c.
Press ▼▲ to adjust the tone of the speaker; 2000 the
maximum, 50 the minimum.
46