Omron E5 D Series Connection Manual page 67

9.6.3. Sequence Settings
The Destination Device executes the "Properties Read" command corresponding to the
communications sequence No. 618 that is used in the protocol data in this guide.
The communications sequence settings include the time for monitoring the send and receive
processing (monitoring time).
Additional Information
For details on communications sequence settings, refer to 5-2 Creating Sequences and
Steps of the CX-Protocol OPERATION MANUAL (Cat. No. W344).
●Monitoring time
The monitoring time (Timer Tr, Tfr, and Tfs) that is set for the communications sequence is
described below.
[Screenshot of the communications sequence settings]
[Settings]
Item Name
Receive wait
Timer Tr monitoring
time
Receive
finish
Timer Tfr
monitoring
time
Send finish
Timer Tfs monitoring
time
Additional Information
For information on the calculation method of monitoring time, refer to 4-5 Calculation Method
of Monitoring Time of the CX-Protocol OPERATION MANUAL (Cat. No. W344).
Monitors the time from when the receive command of the step in
the sequence is recognized until the first byte (header) is
received. This timer is set to 3 seconds in the protocol data used
in this guide.
Monitors the time from reception of the first byte to reception of
the last byte of the data in the step in the sequence.
This timer is set to 3 seconds in the protocol data used in this
guide.
Monitors the time from transmission of the header to
transmission of the last byte of the data. This timer is set to 3
seconds in the protocol data used in this guide.
Description
9．Program
64