Table of Contents
Advertisement
4
The setting items of "Port1:
Protocol macro Settings" are
listed as shown in the figure on
the right.
(The figure on the right shows
the default values.)
5
Select User settings from the
pull-down list of Set Value for
"Port1: Port settings".
6
Set the following parameters in
the same way as step 5.
・Serial communications mode:
Protocol macro
・Data length: 7 bits
・Stop bits: 2 bits
・Parity: Even
・Baud rate: Default(9600bps)
・Protocol macro Transmission
method: Half-duplex
*Use the default values for other
parameters.
Click Transfer[PC to Unit].
7．Serial Communications Connection Procedure
26
Advertisement
Table of Contents
