Omron E5 D Series Connection Manual page 58

9.4.2. Lists of Allocations
The tables below list the addresses necessary to execute this program.
●CIO area
These addresses are allocated and fixed in the CIO area according to the unit number (unit
address) that is set for the SCU.
Unit number 0 is used in this program.
Address
1509 UINT
1509.10 BOOL
1509.11 BOOL
1509.15 BOOL
Additional Information
For details on the CIO area allocated to the SCU, refer to 2-3-2. CIO Area of the CJ Series
Serial Communications Units OPERATION MANUAL (Cat. No. W336).
●Related auxiliary area
The following address is allocated and fixed in the related auxiliary area according to the
communications port number (logical port) that is specified in the program (PMCR
instruction operands).
The communications port No. 7 is used in this program.
Address
A202.07 BOOL
Additional Information
For information on the related auxiliary area for the PMCR instruction, refer to Related
Auxiliary Area Words and Bits in Serial Communications Instructions (PMCR) in SECTION 3.
Instructions of the CJ Series Programmable Controllers INSTRUCTIONS REFERENCE
MANUAL (Cat. No. W474).
Data type
ProtocolMacroErrorCode_SCU_0_P1
SequenceAbortEndCompletion_SCU_0_P1
SequenceEndCompletion_SCU_0_P1
ProtocolMacroExecuting_SCU_0_P1
Data type
CommPortEnabledFlag_P7
9．Program
Variable name
Variable name
55