7.3.5.
Transferring the Project Data
Transfer the created project data to the PLC.
1
Select Programs in the project
workspace of CX-programmer.
Select Transfer - To PLC from
the PLC Menu.
2
Select Program(s), Comments
and Program index. Click OK.
*The I/O table and Special Unit
Setup are unnecessary to
transfer here, because they are
already set in 7.3.3. Creating
an I/O Table and 7.3.4.
Parameter Settings.
*The Comments and the
Program index Check Boxes
may not be displayed
depending on the device type.
In that case, select Program(s)
only and transfer the project
data.
3
The dialog box on the right is
displayed. Confirm that there is
no problem, and click Yes.
7.Serial Communications Connection Procedure
29