Omron E5 D Series Connection Manual page 26

7.3.3. Creating an I/O Table
Create an I/O table for the PLC.
1
If the operating mode of PLC is
Run Mode or Monitor Mode,
change it to Program Mode by
following the steps below.
(1)Select Operating Mode -
Program from the PLC Menu
in CX-Programmer.
(2)The dialog box on the right is
displayed. Confirm that there
is no problem, and click Yes.
*Refer to Additional Information
on the previous page for the
settings concerning the dialog
display.
(3)Check that Stop/Program
Mode is displayed to the right
of the PLC model in the
project workspace of
CX-Programmer.
2
Select Edit - I/O Table and Unit
Setup from the PLC Menu in
CX-Programmer.
The PLC I/O table Window is
displayed.
Precautions for Correct Use
The PLC will be reset after creating and transferring an I/O table in step 3 and the
subsequent steps. Always confirm safety before creating and transferring an I/O table.
7．Serial Communications Connection Procedure
(Project workspace)
23