Loadsharing Enable - H3C S7500 Series Command Manual

Command Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
UpLink monitor information
No. Dest_IP_Addr
1 192.168.0.35
The above information shows there are 135 Layer 3 connectivity errors between the
local device and the remote device whose IP address is 192.168.0.35.

3.1.14 loadsharing enable

Syntax
loadsharing enable
undo loadsharing enable
View
System view
Parameters
None
Description
Use the loadsharing enable command to enable system load sharing.
Use the undo loadsharing enable command to disable system load sharing.
By default, system load sharing function is disabled.
With system load sharing enabled, when an LPU receives traffic to be cross-card
forwarded, load sharing is performed between the active SRPU and the standby SRPU.
Note:
Only unicast traffic supports load sharing.
Only Salience III or Salience III Plus SRPU supports load sharing.
Only LPUs of XGbus type support load sharing.
Examples
# Enable system load sharing.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] loadsharing enable
Dest_MAC_Addr Vlan
----.----.----
3-10
Chapter 3 Device Management Commands
Port ErrCnt
1 - 135
Last_Err_Time
04/29 16:15:04