Qe Monitor Errpkt Check-Time - H3C S7500 Series Command Manual

Command Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
runt: Specifies to detect error packets that are of runt type on current interface. Error
packets that are of runt type refer to frames whose data segment is less than 64 bytes
without CRC errors.
Description
Use the qe monitor errpkt command to configure error packets detection function on
current interface.
A switch does not detect error packets on current interface by default.
If the switch receives a great number of error packets, it will not be able to send/receive
packets properly. With error packets monitoring enabled, the switch collects information
about received error packets regularly. If error packets are detected, it takes protection
measures to ensure that its interfaces send/receive packets properly.
Examples
# Specify to detect error packets that are of runt type on Ethernet 4/0/1 interface.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] interface Ethernet 4/0/1
[H3C-Ethernet4/0/1] qe monitor errpkt runt

3.1.18 qe monitor errpkt check-time

Syntax
qe monitor errpkt check-time interval
View
System view
Parameters
interval: Specifies the interval for detecting error packets. The interval argument ranges
from 1 to 3600 (in seconds) and defaults to 5.
Description
Use the qe monitor errpkt check-time command to set the interval for detecting error
packets.
If the switch receives a great number of error packets, it will not be able to send/receive
packets properly. With error packets monitoring enabled, the switch collects information
about received error packets at intervals. If error packets are detected, it takes
protection measures to ensure that its interfaces send/receive packets properly.
Chapter 3 Device Management Commands
3-13