Uplink Monitor - H3C S7500 Series Command Manual

Command Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Examples
# Set the lower temperature limit of card 0 to 10, and upper temperature limit to 75.
<H3C> temperature-limit 0 10 75
Success temperature limit set successfully

3.1.25 uplink monitor

Syntax
uplink monitor ip ip-address
undo uplink monitor ip
View
Ethernet port view
Parameters
ip-address: IP address of a interface on the Layer 3 device in the remote peer. The
interface connects with the local device.
Description
Use the uplink monitor ip command to enable the Layer 3 connectivity detection
function on the current port, and specify the IP address to be detected, that is the IP
address of the interface on the remote device that connects with the local device.
Use the undo uplink monitor ip to disable the Layer 3 connectivity detection function.
By default, Layer 3 connectivity detection function is disabled on all ports.
Note:
This function requires no Layer 3 device existing between the local peer and the remote
peer.
Examples
# Enable Layer 3 connectivity detection function on Ethernet 4/0/1, and specify the IP
address to be detected as 1.1.1.1.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] interface Ethernet 4/0/1
[H3C-Ethernet4/0/1] uplink monitor ip 1.1.1.1
Chapter 3 Device Management Commands
3-19