What Do You Do In The Event Of A F A U L T - Siemens AlgoPilot B3Q661 Operating Instructions Manual

What do you do in the event of a F A U L T?

Perform the following steps to process a fault:
Fault /
General steps
Step
NOTE:
See below for detailed description for specific faults.
Defective
automatic detec-
tor
Perform the following steps to rectify a fault caused by a defective automatic detector:
Step
20
Building Technologies
Fire Safety
Action
Press <Acknowledge> button to confirm the message.
1
Read the fault location on the display.
2
Go to the fault location
3
Rectify problem which triggered the fault message.
4
If the fault cannot be rectified, you should call the local Siemens Service Organ-
ization.
FAULTS
01 Detector
Action
Find location of defective detector
1
2 IF
No detector
Detector defective
Main building / 1st floor
Room 102
Full message
Functions for
sel. message..
THEN
Reinsert detector
Replace with spare detector
Important: Replace with detector of the same type
only.
Operating instructions Œ•Ž
Total: 1
Operate..
A6V10225450_b_en_--
2017.09.07