Siemens AlgoPilot B3Q661 Operating Instructions Manual page 52

INSTALLATION TEST,
Perform the following steps to reset all detector zones to 'Normal operation' operating mode:
Resetting
all detector
zones
within one -
SECTION to
'Normal
operation' oper-
ating mode
Step
A summary section message is displayed under the following conditions:
NOTE
· When the section only contains zones of the same type.
· When all these zones are in the 'Installation test' status.
If this collective message is present, it can be used to reset all the section's zones to normal op-
eration (via
52
Building Technologies
Fire Safety
continued
Action
Press button <Information>
1
Select one of the detector zones to
2
be reset to 'Normal operation'
Press softkey
3
<Functions for sel. message..>
Press softkey
4
<Select SECTION->
Press softkey
5
<DETECTOR zone functions..>
Press softkey
6
<All DETECTOR zones
-> INST. TEST OFF>
<Functions for sel. message..>).
Operating instructions Œ•Ž
Result / Comment
Use the scroll keys on the display
F
See note below
Implementation messages
'Implementing ...'
'Implemented'
A6V10225450_b_en_--
- and -
2017.09.07