Siemens AlgoPilot B3Q661 Operating Instructions Manual page 49

Testing MANUAL CALL POINTS ,
This procedure describes the test principle for manual call points of type DM1103, DM1133,
Testing DM11x3
DM1153, Sinteso
/ FDM223 type
manual call
Perform the following steps to test these types of manual call point:
points
Step
This procedure describes the test principle for manual call points of type DM1104, DM1134,
Testing DM11x4
DM1154 ('direct operation' type).
type manual call
points
Perform the following steps to test these types of manual call point:
Step
NOTE Once testing is complete, the 'Test condition' operating mode must be ended.
F
Also refer to following chapter:
· "TEST CONDITION per SECTION" on page 42
· "TEST CONDITION per LINE" on page 44
· "TEST CONDITION per ZONE" on page 46
Building Technologies
Fire Safety
TM
FDM223 ('indirect operation' type).
Action
Set corresponding manual call
1
point zones to 'Test condition' op-
erating mode
Use key to open doors of manual
2
call point.
Press button
3
à 'Test alarm' is simulated
Wait until response indicator on
4
manual call point flashes
Close doors again.
5
Action
Set corresponding manual call
1
point zones to 'Test condition' op-
erating mode
Use key to open doors of manual
2
call point.
à 'Test alarm' is simulated
Wait until response indicator on
3
manual call point flashes
Close doors again.
4
continued
Result / Comment
The function test is complete.
Continue with the next manual call
point
Result / Comment
The function test is complete.
Continue with the next manual call
point
Operating instructions Œ•Ž
Press button
Key
Key
A6V10225450_b_en_--
2017.09.07
49