Siemens AlgoPilot B3Q661 Operating Instructions Manual page 93

Menu types and properties,
The main menu consists of up to 6 predefined softkeys. One of these is the navigation softkey
Main menu
<Escape>, which takes you back to the primary menu. The other 5 softkeys can be used to ac-
cess all the system functions available.
Settings..
Alarming..
Softkeys which are followed by two dots (..) take you to a sub-menu. Both the primary menu and
Sub-menu
the main menu may feature softkeys for executable functions and softkeys for sub-menus.
Sub-menus have a hierarchy structure. This produces a menu tree.
If too many functions need displaying on one and the same hierarchical level, the menu can be
Menu
extended. But this is not the same thing as a sub-menu because here all the softkeys are at the
extension
same hierarchical level.
The menu only shows permitted functions. It is therefore dependent on the status of the corre-
Status
sponding system part, e.g. zones of a section.
dependency
Example:
IF
off
All DETECTOR zones
-> OFF
Building Technologies
Fire Safety
continued
Softkeys on left
Commands for switching zones, depending on actual status:
all zones
IF
= test condition
THEN
these commands
change over the zones immediately
Softkeys on right
Direct access..
Bwows..
Escape
all zones
= test condition on
All DETECTOR zones
-> ON
Basic system information &
different
IF
zone statuses
in this section
DETECTOR zones
ON/OFF functions
All DETECTOR zones
-> OFF
All DETECTOR zones
-> ON
THEN
the zones are changed over using
this sub-menu
A6V10225450_b_en_--
93
2017.09.07