Switching Detectors Off/On - Siemens AlgoPilot B3Q661 Operating Instructions Manual

Switching DETECTORS OFF/ON

Only if it is damaged or defective until the point at which the detector is replaced.
When does a de-
tector have to
be switched off?
· A switched off detector cannot produce messages.
i
· It is only a good idea to switch off detectors if the corresponding ZONE is switched on.
If you still don't have operating access when starting operation work, the release procedure is
Operating ac-
automatically called up.
cess
Perform the following steps to switch OFF an individual detector:
Switching off
detectors using
menu
Step
NOTE:
If all the elements of an AREA are OFF, the corresponding zone is automatically switched off,
and all element Isolation messages are deleted.
In this case, reactivation is only possible at 'ZONE' level.
34
Building Technologies
Fire Safety
Action
Press softkey
1
<Operate..>
Press softkey
2
<Browse..>
Press softkey
3
<Browse FIRE
DETECTION..>
Press softkey
4
<Select SECTION¯>
Press softkey
5
<Select ZONE¯>
Press softkey
6
<Select ELEMENT¯>
Press softkey
7
<Other functions..>
Press softkey
8
<Element -> OFF>
Operating instructions Œ•Ž
Result / Comment
The main menu appears on the display.
The sub-menu is displayed.
The AREAS menu is displayed
Use the scroll keys to select the area you
want.
The SECTIONS menu is displayed
Use the scroll keys to select the section
you want.
The ZONES menu is displayed
Use the scroll keys to select the zone you
want.
The ELEMENTS menu is displayed
Use the scroll keys to select the element
you want.
Implementation messages
'Implementing ...'
'Implemented'
A6V10225450_b_en_--
- and -
2017.09.07