Siemens AlgoPilot B3Q661 Operating Instructions Manual page 31

Switching INDIVIDUAL ZONE OFF/ON (with time limit),
· If the time for which a zone is switched OFF is too short, it can be extended without the zone
Extending the
having to be switched ON in the meantime.
OFF status of an
· The original time limit is replaced by the new one. After this newly defined time, the zone is
individual zone
with time limit
automatically switched back on.
Perform the following steps to extend the time for which a zone is switched OFF with a time lim-
it:
Step
+
Switching ON an
The steps are the same as those described under "Switching ON an individual
individual zone
zone" on page 29.
· You can switch a zone OFF with a time limit and then switch it to the OFF status without a
Mixing different
time limit or vice versa.
OFF statuses
· If the zone in question is already in the OFF status, you will need to repeat the steps taken to
switch it OFF. You have to decide which OFF status you want.
Building Technologies
Fire Safety
Action
Press softkey
1
<Operate..>
Press softkey
2
<Browse..>
Press softkey
3
<Browse
FIRE DETECTION..>
Press softkey
4
<Select SECTION¯>
Press softkey
5
<Select ZONE¯>
Press softkey
6
<Zone -> OFF>
Enter time 'hh:mm'
7
using numerical keys
Press softkey
8
<OFF with time limit>
to complete the input
Operating instructions Œ•Ž
Result / Comment
The main menu appears on the display.
The sub-menu is displayed.
The AREAS menu is displayed
Use the scroll keys to select the area you
want.
The SECTIONS menu is displayed
Use the scroll keys to select the section you
want.
The ZONES menu is displayed
Use the scroll keys to select the zone you
want.
The sub-menu and the time input dialog ap-
pear on the display.
· The cursor indicates the value to be en-
tered and moves on after input.
· Maximum time limit = 18:00 hrs.
Implementation messages
'Implementing ...'
'Implemented'
continued
- and -
31
A6V10225450_b_en_--
2017.09.07