Siemens SITRANS FUH1010 Product Instruction Manual page 19

Liquid ultrasonic flowmeter / interface detector (ifd)
Hide thumbs Also See for SITRANS FUH1010:
Table of Contents

Advertisement

Safety notes
2.5 Safety Notes
Transmitter
● Intrinsically safe connections Class I and II, Division 1, Groups A, B, C, D, E, F and G;
● Nonincendive for Class I, Division 2, Groups A, B, C and D;
● Suitable for Class II, Division 2, Groups E, F and G outdoor (Type 4X), Class III (CSA
● Temperature code T5 at an ambient of 40°C
Sensors
● Intrinsically safe Class I and II, Division 1, Groups A, B, C, D, E, F and G;
● Nonincendive for Class I, Division 2, Groups A, B, C and D;
● Suitable for Class II, Division 2, Groups E, F and G outdoor (Type 4X), Class III (CSA
● Temperature code T6 at an ambient of 40°C
ATEX installation
Read, understand and follow all safety instruction on the electronic media provided. This
equipment complies with Directive 94/9/EC and is rated for use in potentially explosive
atmospheres. The equipment markings are shown and explained below. Equipment must be
installed according to the 1010-389 installation drawing provided on the media. Failure to
install the equipment in the prescribed manner will result in unsafe operation. Follow all
regional safety laws when operating this equipment. When properly installed the equipment
meets the following ATEX ratings as stated in EC-Type Examination Certificate
KEMA03ATEX1134
Transmitter Markings and Explanations
Sensor Markings and E
18
only)
only)
II (1) G [Ex ia] IIC – Transmitter located in the non-hazardous area with intrinsically
safe circuits of category Ex ia, which can be connected to Category 1 Sensors
II 3 (1) G Ex nC [ia] IIC T5 Tamb = 0 to +50°C – Category 3 Transmitter located in
Zone 2 potentially explosive atmosphere area with intrinsically safe circuits of category
ia, which can be connected to Category 1 Sensors in Zone 0
IP65 – Ingress protection against solid bodies, rating of dust-ti
rating of water jets
xplanations
II I G Ex ia IIC T5 Ga Tamb = +60°C – Category 1 Sensors located in Zone 0
potentially explosive atmosphere with intrinsically safe circuits of category Ex ia fo
potentially explosive atmosphere containing gases
ght and against liquid,
FUH1010 IP65 NEMA 4X Precision Volume
Operating Instructions, 01/2013, A5E32122003-AA
Ex
r use in

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents