Image Settings; Figure 4-5 Image Settings - Honeywell 30 Series Configuration Manual

Performance Series IP Camera Software Configuration Guide

Image Settings

Go to Setup Camera Setup  PropertiesImage Settings.
On this page, you can configure the White balance and adjust Image parameters.
Two sets of image settings are available:
•
In Normal Light Mode tab, configure normal situations for image settings.
•
In Profile Mode tab, configure special situations for image settings.
•
Night Mode: Check Enable to apply these settings at and select this mode to apply
the settings at night.
•
Schedule Mode: Check Enable to apply these settings at and select this mode to
apply the settings at a specific period. Enter the time manually in the field.

Figure 4-5 Image Settings

White Balance
Adjust the value for the best color temperature.
Auto: Select it and the camera will automatically adjust the color temperature.
Fixed current: Select it and the camera will use current color temperature value.
Manual: You may manually tune the color temperature by dragging the R Gain and B Gain
slider.
Image Adjustment
Brightness: Adjust the image brightness level (0% to 100%).
Contrast: Adjust the image contrast level (0% to 100%).
Saturation: Adjust the image saturation level (0% to 100%).
Sharpness: Adjust the image sharpness level (0% to 100%).
Gamma curve: Adjust the image sharpness level (0.45 to 1, Detailed to Contrast).
•
Optimize: The system automatically adjusts the gamma curve.
24