Ir Illuminators; Smart Ir; Configuring Image Settings; Figure 4-7 Ir Control Settings - Honeywell 60 Series Configuration Manual

Figure 4-7 IR Control Settings

IR Illuminators

Turn on built-in IR illuminator in night mode: Check to turn on the camera's onboard IR
illuminator when the camera detects low light condition and enters the night mode.
Turn on external illuminator in night mode: Check the connector type to turn on the
camera's external IR illuminator when the camera detects low light condition and enters the
night mode. You should connect an alarm output first.

Smart IR

Anti-overexposure: When checked, the camera automatically adjusts the shutter speed, Gain
and IRIS through algorithm of the firmware in order to avoid over-exposure in the night mode.
IR Adjustment: Adjust the luminance of IR lights.
•
Auto IR adjust: Select it to control the luminance of IR lights automatically.
•
Manual IR adjust: Select it to control the luminance of IR lights manually. To increase the
luminance of IR lights, drag the slider to the right; to decrease the luminance of IR lights,
drag the slider to the left.

Configuring Image Settings

Go to Setup Camera Setup  Image Settings.
On this page, you can configure the White balance and adjust Image parameters.
Two sets of image settings are available:
•
In Normal Light Mode tab, configure normal situations for image settings.
•
In Profile Mode tab, configure special situations for image settings.
Configuring Camera Settings
25