Honeywell 30 Series Configuration Manual page 56

Performance Series IP Camera Software Configuration Guide
3. After you selected an area of interest, enter a name for the new position, which can
contain up to 40 alphabetic and numeric characters.
4. Click Add to enable the settings. The preset positions will be listed on the User preset
locations. (To add more positions you wish, repeat steps 1~3.)
5. Select the preset positions by their checkboxes.
6. Click the move button (>>) to move positions to the Patrol locations window.
7. You may select some or all of the imported positions as the stop points during the tour.
8. Select a preset position when you need to move to a specific place on screen.
Select a preferred Rotate speed or move the preset positions for consecutively displaying
views of multiple positions. The speeds for rotating through each position on a Regional
view window are shown below.
9. Click Save to preserve your configuration.
To remove a preset position from the list, select it and click Remove. You can re-arrange
the order of the position hop on the list using the buttons.
42